CD-ROM Chapters
Introduction
- General Introduction
- For Your Safety
- Tools Required
- Programming the Drive Through LCP
- Diagnostics
Drive Inputs and Outputs
- Control Signals
- Input Signals
- Output Signals
Troubleshooting
- Troubleshooting Tips
- Fault Symptoms in the Display of the Drive
- Fault Symptoms in the Motor
- Warning and Alarm Messages
- Initial Start-Up Procedure
Drives and Motor Applications
- Torque & Current Limit, Unstable Motor Operation
- Trips in Drive
- Common Drives and motor Problems
- Faults in Drive
- Drive Electromagnetic Compatibility
Testing Procedures
Introduction
Static Test
- Soft Charge and Rectifier Circuits Test
- Soft Charge Rectifier Test
- Inverter Section Tests (Only for E Frames)
- Brake IGBT Test
- Intermediate Section Tests
- Heatsink Temperature Sensor Test
- Fan Continuity Tests
Dynamic Test
- No Display Test
- Switch Mode Power Supply (SMPS) Test
- Zero DC Bus VoltageTest
- DC Under Voltage Test
- Input Phase Imbalance Test
- Input Waveform Test
- Input SCR Test
- Output Phase Imbalance Test
- IGBT Gate Drive Signals Test
- IGBT Switching Test
- Brake IGBT Test
- Current Sensors Test
- Fan Tests
- Input Terminal Signal Tests
Initial Start-Up or After-Repair Drive Tests
Initial Start-Up Procedure
Disassembly
- Objective & Introduction
- Control Card Cassette
- Power Card
- Soft Charge Card
- Gate Drive Card
- Capacitor Banks
- Input Terminal Mounting Plate
- Soft Charge Resistor (D & E Frames) and Rectifier Modules (Only D Frames)
- SCR & Diode Modules (Only E Frames)
- IGBT Modules
- Heat Sink Fan
Assembly
- Objective
- Heat Sink Fan
- IGBT Modules
- SCR & Diode Modules (Only E Frames)
- Rectifier Modules (Only D Frames) & Soft Charge Resistor
- Input Terminal Mounting Plate
- Capacitor Banks
- Gate Drive Card
- Soft Charge Card
- Power Card
- Control Card Cassette
Space Parts Finder
Matching the Power Card to Unit